Rockwell Automation 1794-VHSC 1794 FLEX I/O Very High Speed Counter Module User Manual - Manual (Page 28)

20 Rockwell Automation Publication 1794-UM010D-EN-E - July 2013
Install Your FLEX I/O VHSC Module
For specific wiring information, refer to the installation instructions for the
module you are installing in this terminal base unit.
7. Repeat the above steps to install the next terminal base unit.
Ensure that the cover of the FlexBus connector on the last terminal base
unit is in place.
Mount on a Panel or Wall
Installation of a FLEX I/O system on a wall or panel consists of:
• laying out the drilling points on the wall or panel.
• drilling the pilot holes for the mounting screws.
• mounting the adapter mounting plate.
• installing the terminal base units and securing them to the wall or panel.
Use the mounting kit Cat. No. 1794-NM1 for panel or wall mounting.
1794-NM1 Mounting Kit
To install the mounting plate on a wall or panel:
Lay out the required points on the wall or panel as shown in the Figure Drilling
Dimensions for Panel or Wall Mounting on page 21 .
(1.4)
35.5
0 1
7
2
3
4 6
7
8
9
2
+
2
+
1
2
3
4
45323
Millimeters
(inches)
Description Description
1 Mounting plate for adapter 3 Terminal base unit (not included)
2 #6 Self-tapping screws 4 Adapter module (not included)