Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.1 Quick Start Guide - Manual (Page 35)

T RANSFERRING D ATA
31
•
• •
3. Check the box for each point under Selected to add it to Data
Transfer.
4. Click [Save].
5. To confirm the points have been mapped to FactoryTalk
Historian SE, click [Search]. The points you selected for
mapping should have a “Y” in the Created in SE column.
Note: You can also run a search in FactoryTalk Historian SE to verify the
points have been mapped to FactoryTalk Historian SE. See the
FactoryTalk Historian SE User’s Guide for more information.
Created in SE This indicates whether or not the point has
already been matched to the FactoryTalk
Historian SE Server. If the point has
already been matched, then this is
indicated by a “Y” in the Created in SE
column. If not, then this is indicated by an
“N.”
Column Name Column Description