Rockwell Automation 1785-TR10B5 Coax Transceiver for 10BASE5 Installation Instructions - Manual (Page 3)

1785-5.17 - January 1999
Coax Transceiver for 10BASE5 3
Assembly
1. As shown in the figure, insert the two contact springs in the bottom part.
Do not screw in the contact needle.
2. Determine the required coupling point on the coax cable.
3. Place the coax cable in the bottom section.
4. Push the top section onto the bottom section.
5. Screw the socket-head cap screw into the top section using the socket
spanner, and tighten it.
6. Drill into the cable with the drill of the combination tool.
– no protruding wires of the cable shield visible in the drill hole (risk of
short-circuit)
– drill hole penetrates the braiding and foil of the shield so that the
dielectric of the cable (plastic layer between centre conductor and
shield) is visible
7. If it is not possible to drill deeply enough, tighten the socket-head cap
screw further.
8. Screw in the contact needle using the hexagon screw key of the
combination tool.
9. Insert the pre-assembled vampire terminal in the housing of the
1785-TR10B5 until it bottoms and secure it with the M3 screws
included.
For Additional Information
For standards information, go to http://www.ieee.org/ . To download a .PDF
copy of this publication, go to http://www.theautomationbookstore.com/ .
Important: Drill cleanly, i.e.:
Important: Tighten the screw gently!
top section
contact spring
bottom section
contact needle
socket
spanner
socket-head
cap screw
drill
coax cable
(10BASE5)
contact needle
hexagon screw key
socket-head
cap screw