Rockwell Automation 1785-L20C_L40C QUICK START CONTROLNET PLC-5 - Manual (Page 10)

1–2 Before You Begin
Publication 1785-10.7 – October 1997
For this quick start, you need this hardware and software:
Product name: Catalog number:
Hardware
ControlNet PLC-5 processor 1785-L20C, -L40C, L60C, -L80C
ControlNet network access cable 1786-CP
1771 I/O chassis 1771-A1B
power supply 1771-P4S
personal computer your choice
communication interface card 1784-KTCx
Software
RSLogix5 programming software
6200 programming software
RSLinx communication software
1771-P4S
power supply
PLC-5/40C
processor
PC with
Programming
Software
1786-CP
This quick start describes how to:
-
Set up the hardware
-
Configure the I/O chassis
-
Set the ControlNet network address
-
Install the hardware
-
Connect the personal computer
-
Connect your nodes to a ControlNet network
-
Set up the software
-
Use 6200 programming software to enter network parameters and
channel 2 configuration
-
Troubleshoot the processor system
Check Your Components
What You’ll Be Doing In This
Quick Start