Rockwell Automation 1792D-CB18PT ArmorBlock MaXum I/O Cable Bases Series B - Manual (Page 5)

ArmorBlock MaXum I/O Cable Bases Series B 5
Publication 1792D-IN036B-EN-P - September 2000
Attach the Module
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws with a torque of 8 inch-pounds to secure
the module to the base.
ArmorBlock MaXum I/O modules are described in the following
publications:
• 1792D series of ArmorBlock MaXum Installation Instructions
• 1792-TD001B-EN-P ArmorBlock Technical Data
The DeviceNet Network uses advanced network technology,
producer/consumer communication, to increase network
functionality and throughput. Visit our web site at
http://www.ab.com/networks for producer/consumer technology
information and updates.
IMPORTANT
Make sure you properly align the screws to complete
the connections between the module contacts and the
cable contacts.
41715
Screws must be
aligned properly to
complete contact
connections.
Contact
connections