Rockwell Automation 1792D-OB4D ArmorBlock MaXum 8 Output Module Series B - Manual (Page 5)

ArmorBlock MaXum 8 Output Module Series B 5
Publication 1792D-IN003B-EN-P - September 2000
To install the module:
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws with a torque of 8 inch-pounds to secure
the module to the base.
IMPORTANT
Proper alignment of the screws is necessary to
complete the connections between the module
contacts and cable contacts.
IMPORTANT
Dimensions change according to the cable base
and module combination used.
42336
1.9in.
48.26mm
6.85in.
174mm
2.7in.
68.6mm
Align the
screws to
properly
assemble
the
module to
the base.
Cable Base
1792D-CBFM is used
for this example. Assembled
dimensions
in (mm).