Rockwell Automation 1792D-OB4D ArmorBlock MaXum 8 Output Module Series B - Manual (Page 6)

6 ArmorBlock MaXum 8 Output Module Series B
Publication 1792D-IN003B-EN-P - September 2000
Connect the Output Cord Sets to the MaXum Module
This module uses 5 pin micro (12mm) style PCB mounted connectors.
Eight micro caps cover the connectors on your module. Remove the
caps and connect your cables to the appropriate ports.
Use the micro caps to cover and seal unused ports. A pinout diagram
for the connectors is shown below.
Please refer to publication 889-5.0 for Rockwell Automation cables
and cord sets offerings.
ATTENTION
!
ATTENTION:
• Make sure all connectors and caps are
securely tightened to properly seal the
connections against leaks and maintain
IP67 requirements.
• For maximum noise immunity, input and
output cable return wires must be
properly terminated. When inputs and
outputs are connected in loopback, return
wires should be connected together.
• I/O cable length should be less than 30
meters.
41452
Output Micro-Connector
(View into Sockets)
Pin 1 Not Used
Pin 2 Not Used
Pin 3 Auxiliary Power Ground
Pin 4 Output A
Pin 5 Not Used