Rockwell Automation 1769-OV32T Compact Module - Manual (Page 12)

12 Compact 32-point Solid-state 24V dc Sink Output Module
Publication 1769-IN073B-EN-P - September 2005
Labeling for the 1492 Interface Module
Several different stick-on label sets are provided on a single card with 1492 Interface Modules.
Each label set is identified with an I/O module catalog number and words “upper” and
“lower” to identify which terminal strip the label should be affixed to.
The table below identifies the 1769-OV32T 32-point labels and their location on the interface
module. Peel off the appropriate label and apply it to the interface module.
The stick-on labels of the 1492 Interface Module are abbreviated as follows: +V1 = V dc 1,
+V2 = V dc 2, CM1 = Com 1, etc.
NOTE: If the stick-on label set for the 1769-OV32T module is not available, use the 1492
interface module stick-on label set for 1746-OB32 modules.
Terminal Block Labels
Bottom Terminal Block Top Terminal Block
+V1
+V1
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
CM1
CM1
+V2
+V2
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
CM2
CM2
TIP
If you decide to build your cable using another 1746-N3 to terminate
the cable at the 1492 Interface Module end, wire it in the following
manner: Pin 1 to Pin 1, Pin 2 to Pin 2, Pin 3 to Pin 3, etc.