Rockwell Automation Logix5000 Logix5000 Controllers Quick Start - Manual (Page 57)

Publication 1756-QS001E-EN-P - October 2009 57
Program Add-On Instructions Chapter 3
View the Logic of an Add-On Instruction
It’s possible to protect an Add-On Instruction so that you can’t see its logic. You can determine whether an
Add-On Instruction is protected.
1. Select the add-on instruction.
2. Look in the Quick View pane for Source Protection.
If it isn’t listed, then the routine isn’t protected.
To view the logic, right-click the instruction and choose Open Instruction Logic.
Motor_Starter(Motor_St
arter_ST,Stop_PB,Start
_PB,Motor_Out_ST);