Rockwell Automation 1746-NT8 SLC 500 Thermocouple/mV Analog Input Module/ Instructions - Manual (Page 8)

8 SLC 500 Thermocouple/mV Analog Input Module
Publication 1746-IN015C-EN-P - July 2001
Module Installation and Removal
To insert your module into the chassis, follow these steps:
1. Before installing the module, connect ground wire to TB1. See page 15.
2. Align the circuit board of your module with the card guides at the top and
bottom of the chassis.
3. Slide your module into the chassis until both top and bottom retaining clips
are secure. Apply firm even pressure on your module to attach it to its
backplane connector. Never force your module into the slot.
4. Cover all unused slots with the Card Slot Filler, Allen-Bradley part number
1746-N2.
ATTENTION
!
Before installing or removing your module, always disconnect:
•
power from the SLC 500 system
•
any other power sources to the module
•
any devices wired to the module
Failure to observe this precaution can cause unintended
equipment operation and damage.
Top and Bottom Module
Release(s)
Card Guide