Terminal block removal – Rockwell Automation 1746-NT8 SLC 500 Thermocouple/mV Analog Input Module/ Instructions User Manual
Page 9
SLC 500 Thermocouple/mV Analog Input Module 9
Publication 1746-IN015C-EN-P - July 2001
Terminal Block Removal
To remove the terminal block:
1. Loosen the two terminal block release screws. To avoid cracking the
terminal block, alternate between screws as you remove them.
2. Using a screwdriver or needle-nose pliers, carefully pry the terminal block
loose. When removing or installing the terminal block be careful not to
damage the CJC sensors.
Terminal Block Diagram with CJC Sensors
ATTENTION
!
POSSIBLE EQUIPMENT OPERATION
Before wiring your module, always disconnect power from the
SLC 500 system and from any other source to the module.
Failure to observe this precaution can cause unintended
equipment operation and damage.
Terminal Block Release Screws
CJC Sensors
CJC Sensors
Terminal Block Release Screws