Rockwell Automation 1771-DB Basic Module User Manual - Series A - Manual (Page 29)

Using the Serial Ports
Chapter 4
4–5
You can use an Industrial Terminal System as the programming system for
the BASIC Module. Connect the module to CHANNEL C only. You can
construct cable for distances up to 50 feet. Figure 4.3 shows cable
connections to a T3/T4 Industrial Terminal from the program port.
Important: You may continue to use CHANNEL B in existing
installations.
Figure 4.3
Cable Connection to T3/T4 Terminal from the Program Port
You can use a T3 or T4 Industrial Terminal with the following keyboard
revisions:
T3 Series A, Revision H or later
T3 Series B, Revision H or later
T3 Series C, Revision A or later
T4 Series A, Revision F or later
Refer to the Industrial Terminal Systems User’s Manual (Cat. No.
1770-T1, T2, T3), publication number 1770-6.5.3, and PLC-3 Industrial
Terminal User’s Manual (Cat. No. 1770-T4), publication number
1770-6.5.15 for additional information.
4.3.2
Connecting a T3/T4 Industrial
Terminal to the Program Port