Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual - Manual (Page 17)

Rockwell Automation Publication 1734-UM014B-EN-P - June 2013 9
Chapter
2
Install Your Adapter
Overview This chapter describes how to physically install the Series A POINT I/O and
ArmorPOINT I/O 2 Port EtherNet/IP adapters; and how to connect the
adapter to the EtherNet/IP network. The only tools you require are a flat or
Phillips head screwdriver and a drill.
This table lists where to find specific information.
Topic Page
Identify Adapter Components 10
Mount the I/O Adapter 11
Mount the POINT I/O Adapter on a DIN Rail 11
Mount the ArmorPOINT I/O Adapter and Base on a Wall or Panel 12
Install the POINT I/O Adapter Module 13
Install the ArmorPOINT I/O Adapter Module 13
Wire the POINT I/O Adapter 14
Wire the ArmorPOINT I/O Adapter 15
ATTENTION: You must use series C POINT I/O modules with the
adapter. Series A or B POINT I/O modules do not work with the adapter.