Rockwell Automation 1775-S4B,D17756.5.3 User Manual SCANNER/MSG HND - Manual (Page 47)

Getting Started in Report Generation
Chapter 5
5Ć9
REPORT GENERATION ABORTED
At this point, ladder diagram mode is in control.
If the ladder diagram program calls for the 1775-S4B scanner to execute
report generation commands or procedures while the command mode
controls the 1775-S4B scanner, the 1775-S4B scanner does not respond to
the ladder diagram program immediately. In this case, the 1775-S4B
scanner stores as many as 4 report generation instructions in a ladder
diagram program until the 1775-S4B scanner switches to ladder diagram
control. If the ladder diagram program contains more than 4 report
generation instructions and you switch the 1775-S4B scanner to ladder
diagram mode:
The 1775-S4B scanner executes the first 4 instructions in the order that
they were stored.
The 1775-S4B scanner executes any remaining instruction(s) in random
order.
In this chapter, you were introduced to report generation on the 1775-S4B
scanner. The remainder of the publication describes the various parameters,
commands, and functions used to generate reports on the 1775-S4B
scanner.
5.7
Chapter Summary