Rockwell Automation 2711P-RAK6 Cutout Adapter Kit for PVPlus 600 Keypad or Keypad Touch Terminals - Manual (Page 4)

4 Cutout Adapter Kit
Publication 2711P-IN021A-MU-P
Disconnect the Terminal
1. Disconnect power at the source and remove the power cord from the
PanelView terminal.
2. Disconnect all communication cables from the terminal.
Remove the Existing Terminal
1. Remove the mounting clips that secure the terminal in the panel.
2. Slide the existing terminal out from the panel.
ATTENTION
!
Make sure the power cord of the PanelView terminal is
disconnected and that all cables have been
disconnected from the terminal.
TIP
The PanelView Standard/PanelView “e” mounting clips are
different than the PanelView Plus/VersaView CE mounting
clips. Store the mounting clips separately to avoid confusion
later.