Rockwell Automation 2711P-RAK6 Cutout Adapter Kit for PVPlus 600 Keypad or Keypad Touch Terminals - Manual (Page 6)

6 Cutout Adapter Kit
Publication 2711P-IN021A-MU-P
Attach Terminal to the Adapter Plate
1. Insert the new terminal into the front of the enclosure until the terminal gasket is
flush with the adapter plate.
2. Insert all 6 mounting levers into the mounting slots of the terminal (as shown below).
Slide each lever until flat side of lever touches the surface of the panel.
3. When all levers are in place, slide each lever an additional notch or two until you hear
a click.
Rear Adapter
Plate Clamp
Nut and
Washer
Rear of Panel
or Enclosure
Mounting Levers
Rear of PanelView Plus
600 Keypad or
Keypad/Touch Terminal
Mounting Lever Mounting Slots
Flat Side of Lever