Rockwell Automation 6185-E 20 Inch Flat Panel Monitor Installation - Manual (Page 17)

Industrial 20.1" Flat Panel Monitor 17
Publication 6185-5.2
You may also need to adjust the brightness or contrast of the screen
image based on the conditions of the location in which the monitor is
installed.
Adjusting Settings
Use these instructions to adjust the video settings to achieve the best
screen image.
Note: For more information on the location and operation of the
controls on the monitor, refer to Page 19.
Step 1 - Start the Adjustment Utility
1. Insert the diskette which was provided with the monitor in the floppy
drive of the host computer
2. Start the Flat Panel Monitor Adjustment utility using the instructions
on the diskette label.
The utility displays an image on the screen to assist you in adjusting
the monitor settings.
Note: The utility may take several seconds to display the
screen image.
Step 2 - Access the controls and use the auto-adjust feature
1. Loosen three of the four screws on the access panel on the back of
the unit.
2. Slide the access panel to reveal the control panel inside the unit.
3. Press the CLK- and CLK+ simultaneously to enable the auto-adjust
feature. The monitor will attempt to adjust the settings properly
based on the current signal. This process may take up to 20 seconds,
during which time the screen will be dark.
4. Do one of the following:
•
If the display looks acceptable, go to Step 6.
•
If the display does not look acceptable, repeat the auto adjust
process two or three more times. If the display still does not look
acceptable, proceed to the next step.