Rockwell Automation 6180 Removable Media CD ROM Floppy Drives (for 6180 Industrial Computers) - Manual (Page 3)

Removeable Media 3
To remove a front or rear facing drive:
1. Disconnect power from the 6180 Computer.
!
ATTENTION: Disconnect all power before
adding/removing components. Failure to disconnect
power could result in severe electrical shock or damage
to the 6180 Computer.
2. Remove the back panel.
Front Bezel
Latching Screws (3)
Front Bezel
Hinge On This Side
Chassis Swings Away
From Bezel
Back Panel
Retaining Screws
Back Panel
Chassis Knockout
For Upper Bay Mounting
Cover Knockout
for Rear Mounting of Drive
3. To remove the drive, it may be helpful to swing the chassis away
from the front bezel. Remove the three latching screws that
secure the front bezel. Note the following precautions before
swinging the chassis away from the bezel.
!
ATTENTION: Remove all cables from the the side
panel connectors. Failure to remove cables may cause
damage to the cables and connectors.
!
ATTENTION: If the 6180 Computer is installed with
mounting clips, the mounting clips on the hinge side
will interfere with the opening of the hinge. Remove
the mounting clips on the hinge side before swinging
chassis away from the bezel. Failure to remove clips
may damage clips and the chassis.