Rockwell Automation 6180 Removable Media CD ROM Floppy Drives (for 6180 Industrial Computers) - Manual (Page 6)

Removeable Media 6
Notes:
You may have to remove the panel knockout (shown on page 2) if
a rear mounted floppy drive was not previously installed.
If you are installing a front facing CD ROM drive, a rear cover
(Catalog No. 6189-FCDBRKT) should be installed on the back
panel.
If you are installing a rear facing CD ROM drive, covers (Catalog
No. 6189-RCDBRKT) should be installed on the front bezel and
rear panel.
For additional information on mounting brackets and covers, refer
to the 6180 Industrial Computer Accessory Mounting Brackets
and Covers publication.
7. Apply power to the 6180 Computer and verify operation of the
drive. You may need to update the BIOS settings, refer to the
Processor Board manual.
If the eject button will not eject the CD tray, use the following
emergency eject procedure.
1. Turn off the power to the computer and wait approximately 1
minute to allow the CD to stop spinning.
2. Insert a paper clip into the emergency eject hole and push in as
shown below. The tray will open.
CD ROM
Emergency Eject