Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 40)

40 Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
Chapter 4 Component Replacement
5. Remove the weight from the drive tray.
a. Remove the four mounting screws from the bottom of the weight (C).
b. Detach the tray from the weight (D).
6. Install the new HDD module to the tray.
a. Install the new HDD module with
the PCB-side down.
b. Fasten the tray over the HDD module
(E).
c. Secure the tray to the HDD module
with the four mounting screws (F).
Torque the screws to 0.59 N•m
(5.2 lb•in).
7. Return the HDD assembly into its bay
(G).
8. Tighten the two captive thumbscrews of
the HDD assembly to secure it to the computer (H).
9. Reinstall the security screw removed in step 3 .
10. Follow the steps for Post-configuration on page 35 .
ATTENTION: Mechanical shock can damage a HDD module. Do not drop
or bump the HDD module.
Weight
HDD Tray
Mounting Screws (4)
HDD Module
C
C
C
C
D
F
F
F
F
E
G
H
H