Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual User Manual
Page 42
42
Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
Chapter 4
Component Replacement
6. Remove the screw securing the slot cover of the selected PCI slot (E).
7. Pull out the slot cover (F) and store it.
8. Remove the add-in card from its protective packaging.
9. Slide the add-in card into the selected PCI slot (G).
Press to make sure it is firmly seated.
10. Secure the add-in card bracket to the chassis with its screw (H).
11. Connect any necessary cables to the add-in card.
12. Replace the center support and
expansion board hold-down
bars.
a. Align the center support (I)
and the hold-down bar ( J)
against the chassis.
b. Secure each bar with four
screws (K).
IMPORTANT
Do not discard the slot cover. If the add-in card is removed in the
future, the slot cover must be reinstalled to maintain proper cooling.
H
G
E
F
J
K
I
K
K
K