Rockwell Automation 6153 Industrial Computers (6153, 6154) - Manual (Page 19)

Bulletin 6153 and 6154 Industrial Computers with Integrated CRT 19
Publication 6153-2.0
You will need to connect a number of cables at the rear of the unit
before your Industrial Computer will function. This section describes
the cable connections you will need to make. While installing cables,
be sure to keep the following points in mind.
•
Connect the cables according to the options in your Industrial
Computer.
•
Route and secure the cables. In cases where the cable crosses a
door hinge, be sure to leave enough excess cable for a loose fit in
all door positions.
•
Coil and secure any extra cable length in a convenient location.
Refer to the figures 11 and 12 for help in routing and connecting the
cables required to use your Industrial Computer.
Figure 11 Rear Panel Cable Connections – 4-Slot Units
VGA
KEYBOARD
COM2
DG
AUX 2
– + – + – + – +
VGA
COM1 LPT1
Touchscreen
Serial Cable
(Optional)
Monitor
Power Cord
Video Cable
Front Panel
Keyboard
Connector
Installing Cables