Video cables – Rockwell Automation 6153 Industrial Computers (6153, 6154) User Manual
Page 21
Bulletin 6153 and 6154 Industrial Computers with Integrated CRT
21
Publication 6153-2.0
Video Cables
The HD15 cable is equipped with a conventional HD15 connector at
each end.
Figure 13
Standard VGA Cable
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
HD15
View looking into the Pin End of the
Male connector
Table A
Standard Video Cable Construction
Monitor HD15
Signal Description
Computer HD15
2
Green Video
2
7
Green Video Ground
7
1
Red Video
1
6
Red Video Ground
6
3
Blue Video
3
8
Blue Video Ground
8
5
Composite Sync
5 (Not Used)
11 (Floating)
ID0
11
12 (Floating)
ID1
12
4 (Gnd)
ID2
4
9
Not Connected
9
14
Vertical Sync
14
10
Sync Ground
10
15
Control
15 (Not Used)
13
Horizontal Sync
13
To establish connections between the monitor and the computer:
1. Connect the standard 15-pin connector end of the video cable to
the computer’s video cable’s VGA connector.
2. Tighten the captive screws on the cable connector to secure it.
3. Connect the VGA cable to the connector on the monitor section.
4. Tighten the captive screws on the cable connector to secure it.