Rockwell Automation 2093-ASP06 Kinetix 2000 Shunt Module Installation Instructions - Manual (Page 9)

Kinetix 2000 Shunt Module 9
Publication 2093-IN002A- MU-P - December 2006
Wire should be copper with 75 °C (167 °F) minimum rating.
ATTENTION
To avoid personal injury and/or equipment damage, make sure installation
complies with specifications regarding wire types, conductor sizes, branch
circuit protection, and disconnect devices. The National Electrical Code
(NEC) and local codes outline provisions for safely installing electrical
equipment.
To avoid personal injury and/or equipment damage, make sure motor
power connectors are used for connection purposes only. Do not use them
to turn the unit on and off.
To avoid personal injury and/or equipment damage, make sure shielded
power cables are grounded to prevent potentially high voltages on the
shield.
IMPORTANT
NEC and local electrical codes take precedence over the values and
methods provided.