Rockwell Automation AutoMax Prog Exec V4.2 and Dist. Power System Drive Software Install - Manual (Page 5)

1Ć1
1.0 INTRODUCTION
The products described in this manual are manufactured or
distributed by Reliance Electric Industrial Company.
This manual provides installation instructions for the following
AutoMaxR Programming Executive V4.x and optional Distributed
Power System (DPS) drive software model numbers:
AutoMax Programming Executive Software
D 57C605 SingleĆUser Executive
D 57C606 SingleĆUser Executive Upgrade
D 57C607 SingleĆUser Multicopy Executive
D 57C625 SharedĆUser Executive (5 Users)
D 57C626 SharedĆUser Executive Upgrade
D 57C627 Additional 5ĆUser License for SharedĆUser Executive
DPS Drive Software
D 57C651 SD3000 DPS Software
D 57C652 SF3000 DPS Software
D 57C653 SA3000 DPS Software
D 57C654 SA500 DPS Software
D 57C655 SB3000 DPS Software
D 57C657 SA3100 DPS Software
D 57C650 SharedĆUser License for DPS Software (5 users)
The AutoMax Programming Executive software (Executive
software") is a Microsoft Windowst 95Ćbased application used to
configure, program, and monitor AutoMax Distributed Power
Systems. It includes the editors and compiler necessary to create
application tasks in BASIC, Control Block, and PC/Ladder Logic
languages. It also contains the operating system for AutoMax
Processors.
Important: The AutoMax Programming Executive Software does not
support long file names. While you can use long file names with the
Windows 95 operating system, these extended names are not
supported by the Programming Executive.
The DPS drive software (DPS software") is used to configure,
program, and monitor DPS drives. This software also contains the
operating systems for the Universal Drive Controller modules and
Power Module Interface hardware used to control DPS drives. Each
drive type has corresponding DPS software.
Both the Executive software and the DPS software must be either
singleĆuser or sharedĆuser versions. The DPS software can be used
only with V3.5 and later of the Executive software. DPS software
cannot be used as standĆalone applications. Executive software must
always be installed before any DPS software options.
The Executive software is described in J2Ć3102. The DPS software is
described in the instruction manuals that ship with the software.