3, making a backup copy, 0 making a backup copy – Rockwell Automation AutoMax Prog Exec V4.2 and Dist. Power System Drive Software Install User Manual
Page 9
3Ć1
3.0 MAKING A BACKUP COPY
Before you install and use the Executive software and the DPS
software, you should make a backup copy in case the original is lost
or destroyed. You must use the DOS DISKCOPY command for
backup.
You will need as many formatted floppy disks for the backup
procedure as you have of the Executive and DPS software. Follow
the procedure below to make backup copies of all disks.
Step 1.
DoubleĆclick My Computer.
Step 2.
Select floppy [A:] (or [B:]).
Step 3.
Select Copy Disk from the file menu.
Step 4.
The operating system will prompt you to insert the source
disk into drive A: (or B:). Insert the first disk and strike any
key.
Step 5.
The system will then prompt you to insert the target disk.
Replace the source disk with the target (blank) disk and
strike any key. The display will indicate when the
procedure is complete and allow you to copy the
remaining disks without typing the DISKCOPY command
again. Simply answer yes (Y) to the following prompt:
Copy another (Y/N)?
Step 6.
Use the above procedure to make a copy of all the disks.