Rockwell Automation 6189V-25HDDKIT Hard Drive Upgrade Kit - Manual (Page 8)

8 Hard Disk Drive Upgrade Kit
Publication 6181P-IN007C-EN-P - May 2006
Install the New Hard Disk Drive
Follow these steps to install the hard disk drive (HDD).
1. Attach the HDD to the connector-stabilization plate using four M3 flat-head
screws.
2. Replace the old shim with the new L-shaped shim and place into bracket A.
3. Place rubber shock-mount strip A into bracket A.
4. Place the HDD within rubber shock-mount strip A, sliding the
connector-stabilization plate through the opening of bracket A.
5. Remove the protective paper from the doublestick tape on the
connector-stabilization plate.
6. Connect the IDE adapter/cable to the HDD, aligning pin 1 of the HDD with
the red stripe on the cable.
ATTENTION
Electrostatic discharge (ESD) can damage the computer and components. Make
sure you work in a static-safe environment and wear a grounding strap
whenever handling circuit boards, memory, or other internal components.
TIP
Dielectric layers face the HDD and screws are flush. The HDD label faces the
back cover in all VersaView panel-mount computers.
TIP
Use the shim with gray shock-mount strips. If you have black shock-mount
strips you may omit the shim or replace the strips with catalog number
6189V-25HDDSA.
WARNING
Be careful to install the connector in the proper orientation. The connector is
keyed to help this process. Make sure that the connector is not shifted by row
or column from its correct position.
Old shim L-shaped shim