Rockwell Automation 2755 Undecoded Hand-Held Scanner - Manual (Page 18)

2–3
Publication 2755-6.1
Connecting the Scanner to a Decoder
The scanner interface cable connects to the input port of the decoder.
The following table summarizes the cable and connectors required for
each decoder.
Note: A Gun Adapter (Catalog No. 2755-NC16)
may be required to connect the scanner to some
Series B decoders.
Decoder Type
2755-NC16
Series B
Gun Adapter
Bulletin 2708-DH5
Attended WorkStations
No
Multi-Purpose
Bar Code WorkStation
(Catalog No. 2755-DH1)
No
Single or Dual-Head
Enhanced Bar Code Decoder
(Catalog No. 2755-DS1A, -DD1A)
Required
!
ATTENTION: Do not install or remove the scanner
cables or connectors until the power to the scanner and
decoder is turned off. Failure to follow this caution may
result in damage to the scanner or decoder.
!
ATTENTION: Make sure you use the Series B Gun
Adapter (Catalog No. 2755-NC16, Series B). If you are
ugrading from an earlier version Allen-Bradley hand-held
scanner (such as the 2755-G2 or -G3) which used the
Series A gun adapter, you will need to purchase the series
B gun adapter.