Rockwell Automation 2755 Undecoded Hand-Held Scanner - Manual (Page 20)

2–5
Publication 2755-6.1
Operating the Scanner
1. Check your connections.
•
Is the scanner cable securely attached?
•
If connecting to a High Speed or Enhanced
decoder, is the Gun Adapter present?
•
Is power applied to the decoder?
2. Test the scanner
Aim the scanner at the work
surface and press the trigger.
You should see the red beam
on the work surface, and the
red LED on the back of the
scanner should be on.
3. Scan a label.
Scan a bar code. Adjust the
scanner position so that the scan
beam is centered on the bar
code and overlaps both sides.
When the scanner has read a
symbol:
•
You will hear a beep from the
decoder (if enabled).
•
The green LED will turn on
and remain on until the next
scan.