Rockwell Automation 2711E-NK5 Replacing the PanelView 1400E Keypad Faceplate - Manual (Page 4)

Replacing the PanelView 1400e Keypad Faceplate 4
4. Disconnect the cable from the controller board on the keypad
faceplate. Note the position and orientation of the cable so that
you can reconnect it properly.
5. The keypad faceplate is attached to the terminal by six Phillips
screws, three on each side. Use the No. 2 Phillips screwdriver to
remove them. The location of the screws is shown above.
6. When you have removed all the screws, tilt the unit up into
operating position, holding the faceplate in place. Gently set the
terminal on its bottom.