Rockwell Automation 2711E-NK5 Replacing the PanelView 1400E Keypad Faceplate - Manual (Page 8)

Replacing the PanelView 1400e Keypad Faceplate 8
7. Start the remaining screws around the outside of the terminal.
8. Use the torque wrench to tighten them to a torque of
27 inch-pounds.
9. Connect the cable to P1 on the controller board of the new
keypad faceplate. Be careful to replace the connector with the
same orientation as when you disconnected it. The cable is keyed
to match the connector.
10. Snap the cable into the strain relief clamp, and lock it by pressing
the upper tab.
11. Use the T15 bit to reattach the keypad controller cover plate at
the back of the keypad. Tighten these screws to a torque of
15 inch-pounds.