Rockwell Automation 2711E-NK5 Replacing the PanelView 1400E Keypad Faceplate - Manual (Page 7)

Replacing the PanelView 1400e Keypad Faceplate 7
4. Holding the faceplate in position with one hand, start the middle
screw on one side of the faceplate. Tighten it “finger-tight”, that
is, as tight as you can by hand.
Important: Start these screws very carefully, either by hand
or with a screwdriver; it is very important not to
strip the threads in the screw holes. If you
should strip or cross-thread a hole, it may be
necessary to return the unit for service.
5. Start the middle screw on the other side of the faceplate and
“finger tighten”.
6. Place the terminal on its face.