Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 - Manual (Page 64)

5Ć8 AutoMax Programming Executive Version 3.x
are transferring systems in, enter the system names
separated by commas or spaces. (R)
SystemĆwide information only Ć If this box is selected, only
the system, section, rack, and network databases, and the
system documentation file will be transferred.
Step 4. Select which of the following groups of files you want to
transfer with the system. These files are not necessary
since they can be regenerated from the source files.
Object files Ć the compiled application tasks, parameter
object files, and rack configuration object file(s).
CrossĆreference files
Transfer Tokens (See Appendix N for more information.)
Step 5. Select Help for information about the transfer procedure,
Cancel to return to the System Configurator without
transferring a system, or OK to begin the system transfer.
Figure 5.4 Ć Transfer System
5.1.8 Importing a System from ASD
You can import a system created with the AutoMax Software
Designer (ASD) Version 8.x (M/N 57C310Ć57C313) into the AutoMax
Executive software. The system must not already exist in the AutoMax
Executive software. This procedure does not delete, or alter in any
way, the original ASD system.
The Import procedure will add the system, sections, and racks using
information stored in the ASD file. One section is created for each
network, and all of the racks named with that network's letter are
stored in that section. If a rack is connected to more than one
network, the primary" network is used. The rack's name in ASD (for