Rockwell Automation 8520 9/Series Hardware TAB 5 User Manual
Page 66
Section 5A
9/440 Resolver–based CNC/Drive System
5A-64
Insert this wire:
into this connector
terminal:
and tighten to this
torque value:
U
J10–1
0.56 – 0.62 N–m
(5 0
5 6 lb in )
V
J10–2
(5.0 – 5.6 lb–in.)
W
J10–3
4.
Gently pull on each wire to make sure it does not come out of its
terminal. Reinsert and tighten any loose wires.
5.
Plug J10 into P10.
6.
Insert one of the 24V control power wires into connector terminal
J1–1 and tighten its connector screw (torque value =
0.56 – 0.62 N–m, 5.0 – 5.6 lb–in.).
7.
Insert the other 24V control power wire into connector terminal J1–2
and tighten its connector screw (torque value = 0.56 – 0.62 N–m,
5.0 – 5.6 lb–in.).
8.
Gently pull on each wire to make sure it does not come out of its
terminal. Reinsert and tighten any loose wires.
9.
Plug J1 into P1
10.
Gently pull on each wire to make sure it does not come out of its
terminal. Reinsert and tighten any loose wires.
For more information about connecting motor power to axis modules, refer
to your accompanying 1394 system documentation.