Rockwell Automation 2706-NP5 DL5 OFFLINE PROGRAMMER USER MANUAL - Manual (Page 27)

Chapter 4
Running DL5 Off-line Programmer
4–14
Editing Existing Messages
When you edit an existing message, you may change either the text or the
attributes of the message. The edit screen is shown below.
1. Press [CTRL] [A] to edit attributes.
2. Use the [RETURN] key or the up [
"] and down [#] arrow keys to move
the cursor through the list of attributes.
3. Press [END] to save the attributes.
4. Edit the message text. Press [F1] to see the Help Screen of edit
commands or see the ”F1” Help Screen section on the next page.
Note: If you decide that you prefer the old version of your message,
press [ESC] to abort. Your message will remain unchanged.
5. Press [END] or [CTRL] [Q] to save your changes. The new version of
the message is now stored in the .DL5 message file.
Option 3
Edit or Create
DL5 Messages