Rockwell Automation 2706-NP5 DL5 OFFLINE PROGRAMMER USER MANUAL - Manual (Page 28)

Chapter 4
Running DL5 Off-line Programmer
4–15
”F1” Help Screen
The “F1” Help screen shows the list of edit commands that you can use to
edit messages. The Help screen can only be accessed while you are editing a
message. To see the Help screen press [F1]. The editing functions listed on
the “F1” Help screen are shown in the table below:
Press: To:
[CTRL] A Edit message attributes.
[CTRL] C Center text in block.
[CTRL] D or
[DEL] key
Delete Current Block.
[CTRL] E Erase complete message.
[CTRL] H,
[BACKSPACE],
or z
Move cursor one character to the left.
[CTRL] I, [INS] key Insert Block after current position.
[CTRL] J, [TAB],
[PG DN], or
#
Move cursor one block forward (right).
[CTRL] K, [SHIFT]
[TAB], [PG UP],
or "
Move cursor one block backwards (left).
[CTRL] L, or ! Move cursor one character to the right.
[CTRL] V, or
[CTRL] X
Insert a variable in the message.
[HOME] key Move cursor to first message block.
[ESC] key Quit and do not save message or changes
[END] key, or
[CTRL] Q
Quit and Save message.
Press any key to exit the Help screen and continue editing the message.
Deleting all Files for a DL5 Name
Use the following procedure to delete all files for a specific DL5 name.
These files can be deleted in DOS. Exit to DOS with Option 6 of the Main
Menu.
At the DOS prompt: A:\DL5> type the following command:
DEL FILE NAME*.* [ENTER]
Example: If you wish to delete the files for the DL5 named NEW, you
would type the following at the DOS prompt: A:\DL5>:
DEL NEW*.* [ENTER]
All files for the DL5 named NEW would now be deleted.