Rockwell Automation 2711P-RAK4 Cutout Adapter Kit for PVPlus 400 Keypad and 600 TouchTerminals - Manual (Page 4)

4 Cutout Adapter Kit
Publication 2711P-IN020A-MU-P
Disconnect the Terminal
1. Disconnect power at the source and remove the power cord from the
PanelView terminal.
2. Disconnect all communication cables from the terminal.
Remove the Existing Terminal
1. Remove the self-locking nuts that secure the terminal to the panel.
2. Slide the existing terminal out from panel.
ATTENTION
!
Make sure the power cord of the PanelView terminal is
disconnected and that all cables have been
disconnected from the terminal.