Rockwell Automation 2711P-RAK4 Cutout Adapter Kit for PVPlus 400 Keypad and 600 TouchTerminals - Manual (Page 6)

6 Cutout Adapter Kit
Publication 2711P-IN020A-MU-P
Attach Terminal to the Adapter Plate
1. Insert the new terminal into the front of the enclosure until the terminal gasket is
flush with the adapter plate.
2. Insert 4 mounting levers into the mounting slots of the terminal (as shown below).
Slide each lever until flat side of lever touches the surface of the panel.
3. When all levers are in place, slide each lever an additional notch or two until you hear
a click.
Rear of Panel or
Enclosure
Rear of PanelView Plus
400 Keypad or 600
Touch Terminal
Adapter Plate
Nut and Washer
Mounting Levers
Mounting Lever
Mounting Slots
Flat Side of Lever