Rockwell Automation 8520 9/PC CNC Tool Path Graphics Programming Manual - Manual (Page 15)

9/PC CNC Tool Path Graphics Programming Manual 15
Publication 8520-PM097A-EN-P - September 2001
Figure 5
Coordinate System After Rotation
Selecting a Part Program
To use the Tool Path Graphics feature, you may want to have a part program running. If you
did not select a program to execute, select one now, following these steps:
1. Press the {PRGRAM CHECK} softkey.
2. Select a program. Press {SELECT PRGRAM}. Use the up and down cursors to
select a program.
Press {ACTIVE PRGRAM} to return to level 2 and activate the program.