Rockwell Automation 2706 DL40 Plus Message Displays Firmware Upgrade Utility - Manual (Page 5)

Firmware Upgrade Utility 5
11. During download a progress bar is displayed by the upgrade software:
The DL40 displays the communication configuration:
You can cancel the download at any time by pressing [ESC].
WARNING: When completed, you are prompted to cycle the power on
the DL40 Plus.
12. Press [ENTER] to return to the main menu and select Exit to DOS to
exit the upgrade utility.
13. Make sure that you cycle power to the DL40 Plus for the upgrade to
take effect.
Important: The DL40 Plus clock is reset by your computer during
download. Make sure you check and change the time on the DL40 as
required.
!
ATTENTION: If you abort the download while in progress,
the DL40 Plus may be placed in an un-runnable state. You
must complete the firmware update to ensure proper operation.
The DL40 displays MAIN PROGRAM INVALID if firmware
is not properly loaded
25 % Downloading DL40NA.S28...
Firmware Update
ESC to abort
Test Monitor V1.0
RS-232 19200 N-8-1
Download complete
Cycle the DL40 Plus power
for update to take effect.
ENTER = Ok