Rockwell Automation 2097-TB1 I/O Terminal Expansion Block Installation Instructions - Manual (Page 4)

4 Bulletin 2097 I/O Terminal Expansion Block
Publication 2097-IN005F-EN-P - November 2011
Install the I/O Terminal Expansion Block
Follow these steps to install your I/O terminal expansion block.
1. Wire the I/O terminal expansion block by using the pinout table on page 5 .
2. Connect the I/O terminal expansion block to the I/O connector on the front of the
Kinetix 300 or Kinetix 350 drive by using a screwdriver and torque to 28.2 N•cm
(2.5 lb•in).
1
11
12
20
21
29
30
40
50
GND