Rockwell Automation 2711P-xxxx Adapter Kit for PanelView Std and e Terminals - Manual (Page 6)

6 Adapter Kit for PanelView Standard and PanelView “e” Terminal Cutouts
Publication 2711P-IN010C-MU-P - March 2007
2. Mount the rear adapter plate to the front adapter plate studs from the back
of the panel, flat side of rear adapter plate towards back of enclosure.
Use the 8, 10 or 12 nuts and flat washers to fasten the rear adapter plate to
the studs.
3. Using the torque wrench, tighten the nuts to not more than 1.92 Nm
(17 lb-in) to maintain a NEMA Type 4X rating.
Do not overtighten.
Front Adapter Plate
Rear Adapter Plate
with 12 holes
Front of Panel or Enclosure
Nut and
Washer
Inside of Panel or Enclosure