Rockwell Automation 2711P-xxxx Adapter Kit for PanelView Std and e Terminals - Manual (Page 8)

8 Adapter Kit for PanelView Standard and PanelView “e” Terminal Cutouts
Publication 2711P-IN010C-MU-P - March 2007
The illustration is a view from inside the enclosure. The top or bottom clips
tighten directly to the adapter plate.
3. Tighten the screws on the mounting clips by hand until the gasket seal
contacts the mounting surface uniformly.
4. Using the torque wrench, tighten the screws on the mounting clips to the
specified torque rating provided in the installation instructions for the new
terminal.
This is necessary to maintain a NEMA Type 4X rating. Do not overtighten.
ATTENTION Tighten the mounting clips to the specified torque to provide a proper seal and
to prevent potential damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the product or other equipment
within the enclosure because of improper installation.
Adapter Plate
Mounting Clip
Adapter Bar
Nut
and
Washer
Panel or Enclosure
Mounting Clip Slot
Back of Terminal