Rockwell Automation T3420AF ICS Regent Analog Input Modules - Manual (Page 13)

Analog Input Modules (T3420A, AF)
P D - 6 0 2 3 M a r - 0 6
13
Figure 6. Fault Tolerant Analog Input Configurations.
Field Wiring
Field wiring terminal blocks on the I/O chassis are used to
connect the analog input signal wiring to the module. The
terminal blocks are located directly above and below the slot
where the module is installed. Each terminal block consists of
10 #6 wire clamp screw terminals capable of holding two 12
AWG wires. Figure 7 shows the proper connection of 16-
channel single-ended analog input signals to the input wiring
terminals. Figure 8 shows the proper connection of eight-
channel differential analog input signals.
The analog input module does not provide the loop power for
the analog input signals. If you interface two-wire Important!