Rockwell Automation T3418F ICS Regent Monitored Digital Input Modules, Field Powered (Type F) - Manual (Page 10)

Monitored Digital Input Modules, Type F (T3411F, T3418F)
1 0
Industrial Control Services
Figure 5. Fault Tolerant Monitored Digital Input Modules
Connected to Redundant Sensors.
Field Wiring
Field wiring terminal blocks on the I/O chassis are used to
connect the field power supply and field input wiring to the
monitored input module. The terminal blocks are located
directly above and below the slot where the module is
installed. Each terminal block consists of ten #6 wire clamp
screw terminals capable of holding two 12 AWG wires.