Rockwell Automation 20G PowerFlex 750-Series Replacement Board Kits - Manual (Page 8)

Rockwell Automation Publication RA-IN028C-EN-P - January 2013
8 PowerFlex 750-Series Board Replacement Kits
600/690V Frame 6 Drives – Power Interface Boards (Continued)
ATTENTION: Replacing the Power Interface Boards will result in the loss of drive data including elapsed power
consumption, elapsed run times, and preventive maintenance data.
3
1.3 N•m (12 lb•in)
T20
M6 x 1.0
2.6 N•m (23 lb•in)
PE-B
IMPORTANT: Note position of the PE-B
jumper wire before disassembly. Use
the same position when installing the
replacement board.
Positions are identified in Step 1 on
page 5 .
ATTENTION: Hazard of equipment damage exists if any board connector is not in full contact with its corresponding
socket when power is applied. When installing the replacement board, be sure the pin connector is aligned, all plugs are
fully seated, the PE-B jumper wire is properly terminated, and all fasteners are installed and torqued as indicated.