Rockwell Automation 1440-TB-B XM-941 Speed/Position Terminal Base - Manual (Page 13)

XM-941 Speed/Position Terminal Base 13
Publication GMSI10-IN021A-EN-P - May 2010
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Hook the lip on the rear of the terminal base onto the top of the DIN
rail, and rotate the terminal base onto the rail.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a
screwdriver or similar device to open the locking tab, press down on
the terminal base until flush with the DIN rail and release the locking
tab to lock the base in place.
5. Connect the wiring for the XM-941 terminal base unit as shown
under Wiring later in this document.
Interconnecting Terminal Base Units
Follow the steps below to install another terminal base unit.
1. Position the terminal base on the 35 x 7.5mm DIN rail (A).
2. Make certain the side connector (B) is fully retracted into the base
unit.
IMPORTANT
Terminal base units are mounted left to right on the DIN rail.