Rockwell Automation LDAT Integrated Linear Thrusters - Manual (Page 67)

LDAT-Series Integrated Linear Thrusters 67
Rockwell Automation Publication LDAT-IN001A-EN-P - August 2012
Remove Strip Cover
Refer to this figure when removing the strip cover.
1. Remove the M3 x 0.5 x 6 mm flat-head cap screws and the stator cover.
2. Remove the M3 x 0.5 x 6 mm button-head cap screws and the end clamps.
3. Carefully slide the slider cover from the assembly.
4. If you are removing the strip cover to lubricate the linear thruster, you are finished.
5. If you are replacing the strip cover, do the following.
Peel off the low-friction tape from the stator body and the stator cove and discard.
Item Description Item Description
1 Stator cover 4 End clamp
2 Stator cover low friction tape 5 Slider cover
3 Stator body low friction tape
ATTENTION: The slider cover has sharp edges. Use care when handling.
Top View of
LDAT-Series Integrated Linear Thruster
(LDAT-S73010xx is shown)
1
2
4
5
3
4