Rockwell Automation AADvance Controller OPC Portal Server User Manual
Page 24
2-10
Document: 553701
(ICSTT-RM407_EN_P) Issue: 03:
OPC Portal Server User Guide (AADvance Controller)
16)
Right-click to open the properties for the server, select the General tab.
Set the Authentication Level to None.
17)
Go to the Identity tab.
Do the following:
a.
Select the radio button labelled The system account (services only).
b.
Click OK to save the new settings and close the OPC Portal Server
Properties.
c.
If you are not configuring a workgroup to use DCOM, reboot the computer.
The configuration of DCOM is complete.
18)
If you are configuring a workgroup to use DCOM, you must set the OPCEnum
properties. Do the following:
a.
Return to the DCOM Config section of the Component Services applet.
b.
Scroll down to locate OpcEnum.