Rockwell Automation DeviceNet System Quick Reference - Manual (Page 5)

DeviceNet System Quick Reference
DNET-QR001A-EN-E – March 2009 5
Install
Locate and mount the modules. Follow these steps to crimp the connectors.
For thin round media, refer to the DeviceNet Media Design Installation Guide,
publication
DNET-UM072 .
Important: • Do not crimp the edge of the connector cover.
• Do not crimp at the back of the crimp block.
• Be sure to set the connector in the correct orientation.
1. Set the center of the connector cover (see arrows) in the center of the crimp block of the crimp tool.
2. Crimp the connector until you hear the connector lock into place.